GE NX-10 Installation Guide

3. Connect a telephone handset into the RJ11 phone jack connector on NX-535 module.
4. Press the button on the NX-535 module and record your message through the handset.
5. Example: “This is your alarm system calling, press any key to continue” (*)
6. Press the button again to stop recording. Your message is automatically played back.
To record the event message #1
1. Go to program mode of Voice module (module 77).
2. Select Location 0:
• Segment 1 = 1 (= record mode)
• Segment 2 = 1 (= event message 1)
3. Connect a telephone handset into the RJ11 phone jack connector on NX-535 module.
4. Press the button on the NX-535 module and record your message through the handset.
5. Example: “Intrusion alarm”
6. Press the button again to stop recording. Your message is automatically played back.
To record the address message
1. Go to program mode of Voice module (module 77).
2. Select Location 0
• Segment 1 = 1 (= record mode)
• Segment 2 = 17 (= address message)
3. Connect a telephone handset into the RJ11 phone jack connector on NX-535 module.
4. Press the button on the NX-535 module and record your message through the handset.
5. Example: “1420 North Main Street Gladewater, press any key to continue”(*)
6. Press the button again to stop recording. Your message is automatically played back.
To record the kiss-off message:
1. Go to program mode of Voice module (module 77).
2. Select Location 0:
• Segment 1 = 1 (= record mode)
• Segment 2 = 16 (= kiss-off message)
3. Connect a telephone handset into the RJ11 phone jack connector on NX-535 module.
4. Press the button on the NX-535 module and record your message through the handset.
5. Example: “The Alarm message has been confirmed”.
6. Press the button again to stop recording. Your message is automatically played back.

GE NX-10 Specifications

General

Brand	GE
Model	NX-10
Category	Security System
Language	English