Location 6 Programming the Closing Time for Schedule 1 (2 segments of numerical data)
Segment 1 Program the hour of the closing time in 24-hour format. (Default is 20 = 8:00 PM)
Segment 2 Program the minutes after the hour of the closing time for Schedule 1. (Default is 0.)
Location 7 Programming the Days for Schedule 1 (1 segment of binary data)
Segment 1
On if schedule is active on Sunday.
On if schedule is active on Monday.
On if schedule is active on Tuesday.
On if schedule is active on Wednesday.
On if schedule is active on Thursday.
On if schedule is active on Friday.
On if schedule is active on Saturday.
On if schedule is disabled during the Holidays.
Location 8 - 28 Programming the Schedules 2 - 8 (1 segment of binary data)
Locations 8 – 28 are used to program the opening times, closing times, and days for Schedules 2 – 8.
Each schedule has three locations that are programmed with the same steps as Schedule 1 described
previously. Refer to Schedule 1 (Locations 5-7 above) for specific instructions.
Location 8 Opening Time for Schedule 2
Location 9 Closing Time for Schedule 2
Location 10 Days for Schedule 2
Location 11 Opening Time for Schedule 3
Location 12 Closing Time for Schedule 3
Location 13 Days for Schedule 3
Location 14 Opening Time for Schedule 4
Location 15 Closing Time for Schedule 4
Location 16 Days for Schedule 4
Location 17 Opening Time for Schedule 5
Location 18 Closing Time for Schedule 5
Location 19 Days for Schedule 5
Location 20 Opening Time for Schedule 6
Location 21 Closing Time for Schedule 6
Location 22 Days for Schedule 6
Location 23 Opening Time for Schedule 7
Location 24 Closing Time for Schedule 7
Location 25 Days for Schedule 7
Location 26 Opening Time for Schedule 8
Location 27 Closing Time for Schedule 8
Location 28 Days for Schedule 8
Location 29 Programming the Date of Holidays in January (8 segments of numerical data)
Program the day of the month in January that the Opening time in a schedule is suppressed. For
example, if the opening should not occur on January 1, program a 1 in Segment 1. This feature can be
repeated up to a maximum of 8 holidays per location (month). (Default is No holidays.)
To Next Page
Loading...
Need help?
General
