GE NX-10 Installation Guide

NX-10 Expander Installation Guide
67
Location Term Definition
8.1.1.1.5.2 Code Stops Timer A menu entry that allows the timer used on programmable
outputs to be reset by entering a valid user code.
8.1.1.1.5.3 Inverted A menu option that enables a mode that inverts the state of
an output (normally activated and then deactivated when
an event occurs).
8.1.1.1.5.4 Disable on Listen-in A menu option that disables the selected output during
listen-in time. This option is normally used to silence sirens
during listen-in. After the listen-in session, the sirens are
activated again.
8.1.2 Users A menu option that specifies the zone or user number that
triggers the output on the expander module or power
module.
8.1.2.1.1 Outputs A menu option that specifies which outputs the selected
user can operate.
8.1.3 Feature Select A menu entry that groups all optional features relating to
the selected module.
8.1.3.1 Mains Delay Time A menu option that sets the length of time between
detecting a mains failure on a power module and sending a
report to the central station. The restore event is sent four
minutes after the mains is restored.
8.1.3.2 Battery Test A menu option that enables a test to determine whether
the battery is connected to the power module. This test is
usually performed automatically when the system is first
powered up and periodically thereafter.
8.1.3.3 Battery Test Time A menu option that sets the length of time that the power
module performs the battery test. This can be between 0 to
255 minutes where 0 is no test.
8.1.3.4 Reports A menu entry that groups report options for the selected
module.
8.1.3.4.1 Report Mains Fail Always A menu option that sends a report to the central station if
power is lost for the time programmed in Mains Delay Time.
If this option is disabled, the report is sent only if the control
panel has not sent a mains power lost report and Mains Fail
report is enabled.
This option applies only to the NX-320-I power module and
not to the control panel.
8.1.3.4.2 Low Battery A menu option that enables low battery reporting on a NX-
320-I power module.
8.1.3.4.3 Siren Tamper/Fault A menu option that sends a report to the central station
when a power module siren tamper or fault condition
occurs.
8.1.4 Model A menu option that displays the current model of the
selected module.
8.1.4 Version A menu option that displays the current software version of
the selected module.

GE NX-10 Specifications

General

Brand	GE
Model	NX-10
Category	Security System
Language	English