GE P54E - Page 695

P54A/B/C/E
Appendix B - Settings and Signals
P54xMED-TM-EN-1
B129
MENU TEXT COL ROW DEFAULT SETTING AVAILABLE OPTIONS
DESCRIPTION
Relay 13
Relay 14
Relay 15
Relay 16
Relay 17
Relay 18
Relay 19
Relay 20
Relay 21
Relay 22
Relay 23
Relay 24
Relay 25
Relay 26
Relay 27
Relay 28
Relay 29
Relay 30
Relay 31
Relay 32
[Binary Flag (32) Indexed String]
This cell is used to select the output relay contacts that will be tested when the ‘Contact Test’ cell is set to ‘Apply Test’.
Test Pattern 0F 0E 0x0
Relay 1
Relay 2
Relay 3
Relay 4
Relay 5
Relay 6
Relay 7
Relay 8
Relay 9
Relay 10
Relay 11
Relay 12
Relay 13
Relay 14
Relay 15
Relay 16
Relay 17
Relay 18
Relay 19
Relay 20
Relay 21
Relay 22
Relay 23
Relay 24
Relay 25
Relay 26
Relay 27
Relay 28
Relay 29
Relay 30
Relay 31
Relay 32
[Binary Flag (32) Indexed String]
This cell is used to select the output relay contacts that will be tested when the ‘Contact Test’ cell is set to ‘Apply Test’.
Contact Test 0F 0F No Operation
No Operation
Apply Test
Remove Test
[Indexed String]
When the ‘Apply Test’ command in this cell is issued the contacts set for operation (set to ‘1’) in the ‘Test Pattern’ cell change state. After the
test has been applied the command text on the LCD will change to ‘No Operation’ and the contacts will remain in the Test State until reset
issuing the ‘Remove Test’ command. The command text on the LCD will again revert to ‘No Operation’ after the ‘Remove Test’ command has