GE PACE6000

GE
Digital Solutions
Pressure Automated Calibration Equipment
User manual - K0443 Revision A
PACE5000
© 2008 General Electric Company. All Rights Reserved. Specifications are subject to change
without notice. GE is a registered trademark of General Electric Company. Other company or
product names mentioned in this document may be trademarks or registered trademarks of their
respective companies, which are not affiliated with GE.
PACE6000
nbn Elektronik Handelsgesellschaft m. b. H.
Riesstraße 146, 8010 Graz | Tel. +43 316 40 28 05 | Fax +43 316 40 25 06www.nbn.at
Vertrieb für Österreich :

GE PACE6000 Specifications

General

Model	PACE6000
Category	Test Equipment
Battery Type	Lithium-ion
Memory	Internal memory for storing test results
Interface	USB
Compliance Standards	CE

Summary

Introduction

Safety

Pressure

Maintenance

General Specification

WARNINGS

Description

Introduction

Details the PACE5000 and PACE6000 capabilities, touch-screen interface, and remote operation.

Installation

Pneumatic Connections

Rack-mount Option

Electrical Connections

Communication Connections

RS232 Interface

IEEE 488 Interface

Operation

Preparation

Power-up Sequence

Describes the instrument's power-up sequence, including self-test and mode changes.

Measure Mode

Control Mode

Control Set-up

Operation and Example Procedures

Task

Explains the Task menu for accessing functions like Basic, Leak Test, Switch Test, and Test Program.

Divider

Preset

Global Set-up Selections

Status Area Settings

Supervisor Set-up

Instrument Status

Software

Maintenance

Calibration

Replacement Parts

Fuse Replacement

Step-by-step guide for replacing fuses in the instrument.

Filter Replacement

Pressure Module Replacement

Testing and Fault Finding

Standard Serviceability Test

Procedure to verify the unit's serviceability and check instrument functions.

Fault Finding

Reference and Specification

Installation Notes

Gas Supply

Requirements and recommendations for the gas supply used with the instrument.

Maximum Working Pressure

The Need for a Negative Supply

Vacuum Pump

Operational Requirements

Measure Set-up

Global Set-up

Status

Communications

RS232

IEEE 488

Ethernet

Ethernet Parameters Range Setup

USB

Gas Head Correction

Power Up

Change PIN

Options

Option Enable Process

Options in the Task Menu

Leak Test Option

Details the Leak Test task for finding leaks in a system connected to the instrument.

Switch Test Option

Test Program Option

Program

Programming Loops

Barometric Reference Option

Aeronautical Option

Leak Testing

Pre-testing procedure to perform a leak test on aeronautical components.

Aeronautical Testing

Details the aeronautical task for controlling and measuring altitude, airspeed, and Mach.

Altitude to Airspeed

Example of Altitude and Airspeed Testing

Control of Aeronautical Parameters

Analogue Output Option

Volts-free Contact Option

Communications - Instrument Emulation

Specification

Safety Precautions

Packaging Procedure