PACE Pressure Controller User Manual
[EN] English 4 - 3 K0443 Revision A
Replace
1. Check for the correct type of fuse (Ref: Table 4.2 Replacement Parts List).
2. Replace the fuse.
3. Refit the fuse carrier (2) in the power supply inlet socket assembly.
4. Refit and reconnect rack-mounted units (Ref: Installation, Section 2).
5. Switch on the power supply and set the power supply switch to ON.
6. If the fuse blows immediately with power-on, contact the manufacturer or Service Agent.
Figure 4-1, Fuse Replacement
1 - IEC connector 2 - Fuse carrier 3 - Fuse
To Next Page
Loading...
