– 57 –
18. Remove the pressure tube from the air chamber
attached to the outer tub.
Note: The pressure tube is diffi cult to remove.
a. Squeeze the clamp and slide it back.
b. Carefully break the tube loose by inserting a
small, fl at blade screwdriver under the tube
to break the seal.
c. Remove the tube.
Ground Wire
19. Remove the top and bottom counterweights.
(See Wash Basket.)
20. Remove the 4 dampers from the outer tub. (See
Dampers.)
21. Depress the dampers and position them toward
the outside of the cabinet.
22. Lift the outer tub assembly, then release the
2 suspension springs from the slotted plastic
inserts in the cabinet's top braces.
23. Carefully remove the tub assembly out thru the
front of the cabinet.
Note: When installing the tub assembly, hook each
of the suspension springs in the forward hole of the
outer tub spring mount and the slot in the insert.
Insert
Suspension Spring
Outer
Tub
Spring
Mount
Forward
Hole
Air Chamber
15. Remove the 4 Phillips-head screws from the
cabinet's rear cover.
16. Pull the rear cover outward from the middle.
17. Remove the Phillips-head screw that holds the
outer tub ground wire. Remove the ground wire
from the outer tub wire guides.
To Next Page
Loading...
