Chapter 10. OPC UA Server
176 PACSystems* RX7i & RX3i TCP/IP Ethernet Communications User Manual GFK-2224Q
OPC UA Server – Service Request – STOP
This function stops the OPC UA Server on the controller. It does not remove or clear the configuration files.
Note: This request can only be successfully performed when the OPC UA server is started.
Parameters for the STOP function service request are:
Parameter Summary
Data Direction
(LD perspective)
16#0001 OPC UA protocol IN
16#0001 STOP request IN
The use of the STOP sub-function code in a ladder diagram is illustrated in the following example. If the
SVC_REQ does not pass power, the operation did not complete.
Example:
To Next Page
Loading...
