Chapter 4. Configuration
44 PACSystems* RX7i & RX3i TCP/IP Ethernet Communications User Manual GFK-2224Q
Figure 22: Defining EGD Consumed Data Exchange
The parameters to be entered and their relevance is discussed in the sections (below) entitled Configuring an
Ethernet Global Data Exchange for a Producer (page 58) and Configuring an Ethernet Global Data Exchange for a
Consumer (page 60).
See also Ethernet Global Data Operation in Chapter 5 for a fuller understanding.
Produced exchanges (Multicast and Broadcast) configured for the CPE330’s embedded Ethernet interface will
have an additional parameter Network ID that allows the user to select LAN1 or LAN2. (Refer to the following
figures).
The Network ID parameter is only visible on produced Multicast and Broadcast exchanges.
To Next Page
Loading...
