GE RX3i

Appendix A. Configuring Advanced User Parameters
GFK-2224Q January 2017 261
TCP Parameters (task w) Default Range
wnodelay
26
TCP nodelay option (0= inactive; 1 = active) 1
(1H)
0, 1
wkal_idle
26
TCP keepalive timer value (in seconds) 240
(4.0 min)
1 − 65535 (ffffH)
wkal_cnt
26
TCP keepalive extra probe count
(in addition to single probe always performed)
2
0 − 65535 (ffffH)
wkal_intvl
26
TCP keepalive probe interval (in seconds) 60
seconds
1 − 65535 (ffffH)
wsnd_buf
26
TCP send buffer size (in bytes) 65535
(ffffH)
0 − 65535 (ffffH)
wrcv_buf
26
TCP receiv
1
e buffer size (in bytes) 4096
(1000H)
0 − 32767 (7fffH)
A-3 AUPs Supported by RX3i CPE305/CPE310 Embedded Ethernet
Interface
The default values and ranges of valid values are the same as those in other PACSystems Ethernet interfaces.
Note: When explicitly configuring speed or duplex mode for an RX3i embedded Ethernet port
using Advanced User Parameters (AUP), do not request a store to flash as a part of the
download when communicating over the CPE305/CPE310 embedded Ethernet port. In
this situation you first must store to the RX3i and then initiate a separate request to write
to flash.
System Memory Parameters (task b)
staudp
stpasswd
Backplane Driver Parameters (task c)
crsp_tout
chct_comp
cstorm
cnostorm
Ethernet Global Data Parameters (task g)
gctl_port
gdata_port
gbcast_ttl
gucast_ttl
gp_phase
gnostale
gXX_udp
gXX_addr
gXX_ttl
IP Parameters (task i)
ittl
ifrag_tmr