Chapter 4. Configuration
42 PACSystems* RX7i & RX3i TCP/IP Ethernet Communications User Manual GFK-2224Q
Terminals Tab
This configuration tab (Figure 18) is displayed only when the Variable Mode property of the Ethernet interface is
set to True. When Variable Mode is selected, the Ethernet Status bits are referenced as I/O variables. The I/O
variables are mapped to the Ethernet status bits via this configuration tab.
Figure 19: Terminals Tab Settings in Proficy Machine Edition
The use of I/O variables allows you to configure the Ethernet interface without having to specify the reference
addresses to use for the status information. Instead, you can directly associate variable names with the status
bits. For more information, refer to “I/O Variables” in the PACSystems CPU Reference Manual, GFK-2222.
To Next Page
Loading...
