GE RX3i - Page 270

Appendix A. Configuring Advanced User Parameters
GFK-2224Q January 2017 257
Network Interface Parameters (task l) Default Range
lduplex0 Ethernet duplex for Controller
0=auto-detect, 1 = half, 2= full)
0 0,1,2
lduplex1a
26
Ethernet duplex for Port 1A
(0=auto-detect, 1=half, 2=full)
0 0,1,2
lduplex1b Ethernet duplex for Port 1B
(0=auto-detect, 1=half, 2=full)
0 0,1,2
lspeed0 Ethernet speed for Controller
(0=auto-detect, 1=10Mbit, 2=100Mbit)
0 0,1,2
lspeed1a
26
Ethernet speed for Port 1A
(0=auto-detect, 1=10Mbit, 2=100Mbit)
0 0,1,2
lspeed1b Ethernet speed for Port 1B
(0=auto-detect, 1=10Mbit, 2=100Mbit)
0 0,1,2
Modbus TCP/IP Server Parameters (task m) None None
Note: SNTP is supported on the embedded Ethernet interfaces of the CPE305/CPE310/CPE330 and CPE400 ONLY
when configured using PME!