GE SIMON XT Installation Manual

Reporting Report options: Opening report, Closing report, Force
armed report, AC power failure report, Panel low
battery report, Sensor alarm restoral report, 24-hour
sensor tamper, Supervisory/tamper report, No usage
report, Swinger shutdown, Programming report, Fire
alarm verification
Communication modes: Phone 1 reports, Phone 2
reports, Phone 3 reports, Phone 4 reports
Timers Latchkey time, Entry delay, Exit delay, No activity
timeout, Auto phone test, Supervisory time, Alarm
cancel window, RF timeout, Fail to open time, Fail to
close time, Siren timeout, Arming LEDs shutdown,
Unvacated premises, Smoke sensor supervision
Touchpad options Keyfob no delay, Panel panic alarms, Remote
touchpad arming
System options RF jam detect, Demo mode, HW1 I/O, 24-hour clock
format
Siren options Piezo beeps, Panel voice, Panel piezo alarm, Trouble
beeps, Voice chime, Status beeps vol, HW siren sup,
Speaker volume, Silent police panic, Alarm report
verify
Auto verification Audio mode, Fire shutdown, Panic talk, VOX receiver
gain, VOX microphone gain, VOX gain range, Manual
microphone gain
System tests Sensor test, Communication test, Initiate download
call
Revision
Contrast
Set clock
If the panel loses both AC and battery power, then upon power restoral the system
time will reset to midnight and blink, indicating it has not been set correctly. You can
set the system time to display in either 12-hour or 24-hour format.
Time of day format is HH:MMx, where:
HH = 01 to 12 (12-hour format) or 00 to 23 (24-hour format)
MM = 00 to 59
X = a or p (12-hour format) or none (24-hour format)
To reset the clock:
1. Scroll until the display shows
Set Clock, and then press OK. The display shows
Enter Code.
24 Simon XT Installation Manual

GE SIMON XT Specifications

General

Brand	GE
Model	SIMON XT
Category	Security System
Language	English