Voice event notification
Testing this feature requires two people; one at the alarm site and the other at the
location the panel is programmed to call.
To test voice event notification:
1. Contact the central monitoring station (if the system is monitored) to inform them
you are testing the system and not to dispatch authorities.
2. At the system site, put the system into an alarm condition.
3. At the calling location, pick up the phone after it starts ringing. You should hear
the panel voice announce Press Star for Alarm.
4. Press * and the panel voice identifies the alarm. If there is more than one alarm in
progress, you must press * for the panel voice to identify them.
After all alarms have been identified, the panel announces Press # to Exit.
5. Press # to terminate the call.
You must terminate the call by pressing #. Otherwise, the panel may not
disconnect from the phone line for up to 2 minutes.
Simon XT Installation Manual 49
To Next Page
Loading...
Need help?
General
