Sensors
Table 14 below describes the Sensors menu.
Table 14: Sensors menu
Function Description
Learn sensors Adds (learns) sensors to panel memory.
Delete sensors Deletes sensors from panel memory.
Edit sensors Edits sensor information in panel memory.
The following instructions tell how to add (learn) sensors, touchpads, and other
system devices into panel memory. The panel recognizes a sensor when you press a
sensor program button, press and release a tamper switch, press a sensor test
button, or put a sensor into alarm. Table 15 on page 32 below describes the
programming method for each device.
When learning (programming) sensors, the panel uses an ascending sequence
starting with 1. You can override this by entering the desired sensor number using the
number keys.
To learn (program) a sensor:
1. Scroll until the display shows System Programming, and then press OK. The
system prompts for an access code.
2. Enter the dealer or installer code and then press OK. The display shows Access
Codes.
3. Scroll until the display shows Sensors, and then press OK. The displays shows
Learn Sensor.
4. Press OK. The display shows Trip Sensor ##, with the number signs flashing.
If you wish to use a sensor number other than the next one available, use the
number keys to enter a two-digit sensor number immediately.
5. Press the sensor program button or release the sensor tamper switch. The display
shows
SN ## Grp10 <Front Door>, with Grp 10 flashing.
6. Use the number or scroll buttons if you want to enter a new group number; press
OK to accept the group number displayed. The sensor text flashes.
7. Scroll through the text list, and then press OK to accept the first text segment.
8. You may enter more text or press OK again to finish adding the sensor. The
display shows Trip Sensor ## (with the next available sensor number).
9. Press Status repeatedly to exit.
Simon XT Installation Manual 31
To Next Page
Loading...
Need help?
General
