GE TLE 160 - Setup Menu and Parameter Configuration; Identification Parameters Setup

Critical Power
Modifications reserved
Page 43/91
GE_UPS_USM_TLE_SUL_M16_M50_2bU_V010.docx
User Manual TLE Series 160 - 500 UL S2B
6.4 SETUP
SETUP
The SETUP mode is entered any time the
“SETUP” key is pressed.
This screen allows the user to modify
some parameters permitting to adapt
some functions of the UPS to his/her
needs, described as follows.
The LCD
will display a series of screens
containing the user parameters,
accessible without password protection.
In this mode the keys perform the following functions:
Shows the main screen MEASURES.
See Section 6.2.
Shows the main screen EVENTS.
See Section 6.3.
Return to HOME screen.
Shows the main screen COMMANDS.
See Section 6.5.
Shows the operating status of the RPA PARALLEL SYSTEM.
See Section 6.6.
Key to reset general alarm and buzzer.
Shows the screen User.
Shows the screen Service Basic.
Reserved for the GE Service Center, at this level the parameters access is protected by a
code.
Shows the screen Service Full.
Reserved for the GE Service Center, at this level the parameters access is protected by a
code.