GE VG4043 - To Change the Signaltype; To Add or Remove Channels

AUTO CHANNEL SEARCH
Now scanning channel 14
Press any key to cancel
TheVCR begins scanning for the available channels--this
takes about one to two minutes.The lowest channel is tuned
once the search is completed. Pressing CHANNEL up or
down now selects the active channels.
To Change the Signal Type
1. Press MENU to displaytheVCR MAIN MENU.
2. Press 3to display the CHANNELS menu.
3. Press 3 to change the SignalType between CABLE and
ANTENNA.
CHANNELS
1 Auto Channel Search
2 Add/Remove Channels
3 Signal Type: CABLE
4 Cable Box Setup
0 Exit
To Add or Remove Channels
You may want to add or delete channels after you Auto Channel
Search, especially if some of the channels have weak signals or
you don't want to watch them.
.
2.
3.
Press MENU to display theVCR MAIN MENU.
Press 3 to display CHANNELS menu.
Press 2 to display the ADD/REMOVE CHANNELS menu. Use
the CHANNEL up or down, or number buttons, to go to the
channels you want to delete or add.
ADD/REMOVE CHANNELS
Channel 115
is presently ADDED
Press CLEAR to remove
Press MENU to exit
ADD/REMOVE CHANNELS
Channel 115
is presently REMOVED
Press INFO to add
Press MENU to exit
r
Selecting Channels
The CHANNEL up and down buttons
access those channels active in your
VCR channel list.
You can still access channels not in
the channel list by using the number
buttons on the remote control.
11