GE Vivid E7

GE
D
IRECTION GB091046, REVISION 2 VIVID E9 / VIVID E7 BT’13 SERVICE MANUAL
Chapter 8 - Replacement procedures 8 - 41
8-5-10-2 Remove the I/O Door (cont’d)
8-5-10-3 Install the I/O Door
Follow these steps to install the Door I/O Panel:
1.) Place the Door I/O Panel into position by sliding lower hinge onto lower hinge post.
2.) Pop the upper hinge into place onto the upper hinge post.
Figure 8-17 Hinge placement on Door I/O Panel
UPPER HINGE
UPPER HINGE
POST
LOWER HINGE
POST
LOWER HINGE