GE Vivid E7

GE
D
IRECTION GB091046, REVISION 2 VIVID E9 / VIVID E7 BT’13 SERVICE MANUAL
8 - 42 Section 8-5 - Replacing Covers and Bumpers
8-5-11 Cable Hooks replacement
8-5-11-1 Preparations
When preparing for the replacement, you must perform the following steps:
1.) Power down the VIVID E9 / VIVID E7
2.) Disconnect the Mains Power Cable from the wall outlet.
3.) Disconnect all probes and external I/O cabling.
4.) Remove the Side Covers.
5.) Remove the Rear Bumper.
6.) Remove Filter Cover at rear.
7.) Remove Filter.
8.) Remove the Top Cover.
9.) Remove the Rear Cover.