GE
D
IRECTION GB091046, REVISION 2 VIVID E9 / VIVID E7 BT’13 SERVICE MANUAL
8 - 98 Section 8-6 - Top Console Parts Replacement Overview
8-6-8-2 Remove the Main Controller Board (cont’d)
7.) Unscrew and remove five (5x) screws. Store them in a safe place, you will need them for the
installation.
8.) Remove the Main Controller Board.
8-6-8-3 Main Controller Board installation procedure
Follow these steps to install the Main Controller Board:
1.) Position the Main Controller Board with the USB board plugged in, so it aligns with the fixing screw
holes in the LCD frame.
2.) Install the five (5x) screws (refer to Figure 8-87).
3.) If removed, install the High Voltage Inverter board.
4.) Connect the three (3x) cables (refer to Figure 8-86).
NOTE: Take care not to damage the EMC gasketing that goes around the Touch Panel Assembly,
especially during re-assembly.
5.) Install the Back Cover.
6.) Install the Operator Panel, Upper.
7.) Install the Control Knobs.
Figure 8-87 Remove screws
To Next Page
Loading...
