GE
D
IRECTION GB091046, REVISION 2 VIVID E9 / VIVID E7 BT’13 SERVICE MANUAL
Chapter 8 - Replacement procedures 8 - 119
8-6-18-2 Lower Switch Board with Elastomer removal
1.) Disconnect the cable to the Encoder Board.
2.) Remove the 26 fixing screws.
3.) Remove the Lower Switch Board with Elastomer. Store it in an ESD safe place.
Figure 8-106 Lower Switch Board with Elastomer - Trackball already removed.
Figure 8-107 Lower Switch Board with Elastomer - Trackball already removed.
To Next Page
Loading...
