GE
D
IRECTION GB091046, REVISION 2 VIVID E9 / VIVID E7 BT’13 SERVICE MANUAL
Chapter 8 - Replacement procedures 8 - 123
8-6-19-3 Install the Lower Bezel
1.) Install the Switch Cups in the correct positions on the Lower Bezel. Use the mirrored image in Figure
8-109 as a reference.
NOTE: THE ILLUSTRATION BELOW IS A MIRRORED ILLUSTRATION.
USE IT FOR REFERENCE WHEN INSTALLING THE SWITCH CUPS!
2.) Install the Lower Switch Board with Elastomer.
3.) Install the Encoder Board.
4.) Install the Trackball.
5.) Install the Operator Panel, Lower.
6.) Install the Operator Panel, Upper.
7.) Install the Knobs for Encoders and Slidepots.
Figure 8-109 Mirrored illustration of the Switch Cups positions
To Next Page
Loading...
