GE Vivid E7 - Page 486

GE
D
IRECTION GB091046, REVISION 2 VIVID E9 / VIVID E7 BT’13 SERVICE MANUAL
8 - 170 Section 8-7 - Replacing XYZ Parts
8-7-4-3 Z-Mechanism installation procedure
1.) Position the Z-Mechanism so the holes for the fixing screws align.
2.) Install two (2x) M6x16 Countersunk and two (2x) M6x16 screws.
3.) Install four (4x) M6x16 (lower part of unit).
4.) Install the XY (Frogleg) Mechanism.
5.) Install the Lower Frame Assembly.
6.) Install the Upper Frame Assembly.
7.) Install the Bulkhead Plate.
8.) Install the Bulkhead Board.
9.) Install the Operator Panel, Lower.
10.)Install the Operator Panel, Upper.
11.)Install the LCD Arm assembly.
12.)Install the LCD Monitor assembly.
13.)Install the LCD Rear Cover.