GE
D
IRECTION GB091046, REVISION 2 VIVID E9 / VIVID E7 BT’13 SERVICE MANUAL
Chapter 8 - Replacement procedures 8 - 233
8-11-1-4 Prepeare the new BEP for installation
1.) If installed, remove the DVR Board from the existing BEP and install it in the replacement BEP.
For instructions, see: 8-14-2 "Digital Video Recorder (DVR) replacement" on page 8-284.
2.) If 4D is installed:
- If the BEP you removed was a BEP6, and the new BEP is a BEP6, you can move over the
Graphics Adapter.
- If the BEP you removed was a BEP5, and the new BEP is a BEP5, you can move over the
Graphics Adapter.
- If the BEP you removed was a BEP5, and the new BEP is a BEP6, you must also order a new
Graphics Adapter.
BEFORE YOU DISPOSE OF THE HARD DRIVE, OR RETURN THE BEP TO THE LOCAL
PARTS ORGANIZATION, MAKE SURE YOU REMOVE ALL PATIENT DATA FROM THE
HARD DRIVE, GIVEN THAT THE HARD DRIVE IS STILL FUNCTIONAL.
IN SOME COUNTRIES, YOU MAY BE REQUIRED TO DELETE ALL SOFTWARE FROM
THE DISK BEFORE RETURNING THE HARD DRIVE TO THE PARTS WAREHOUSE.
FOLLOW YOUR LOCAL POLICIES.
To Next Page
Loading...
