GE
D
IRECTION GB091046, REVISION 2 VIVID E9 / VIVID E7 BT’13 SERVICE MANUAL
8 - 242 Section 8-11 - Back End Processor (BEP) parts replacement
8-11-3-1 Preparations (cont’d)
3.) If possible, wipe the HDD partitions as described here: Reload the system software from DVD.
Select A: to overwrite all content on HDD.
4.) Power down the VIVID E9 / VIVID E7.
5.) Disconnect the Mains Power Cable from the wall outlet.
6.) Disconnect all probes and external I/O cabling.
7.) Remove the Left Side Cover.
8.) Remove the BEP Cover.
a.) Loosen the BEP Cover’s fixing screw(s).
- On BEP6 there are two finger screws on the top of the BEP Cover.
b.) Tilt the top of the BEP Cover away from the BEP.
c.) Set the BEP Cover aside.
To Next Page
Loading...
