GE
D
IRECTION GB091046, REVISION 2 VIVID E9 / VIVID E7 BT’13 SERVICE MANUAL
8 - 264 Section 8-11 - Back End Processor (BEP) parts replacement
8-11-9-3 Patient I/O Interface Cable installation
Follow these steps to install the Patient I/O Interface Cable:
1.) Connect the two connectors (Power and USB) to the Patient I/O.
2.) Connect the other end of the cable to CN USB11 on the BEP’s motherboard.
3.) Install the BEP Power Board.
4.) Install the BEP Cover.
5.) Install the Left Side Cover.
BE AWARE OF CORRECT ORIENTATION OF THE PATIENT I/O CABLE CONNECTOR WHEN
CONNECTING TO CN USB11 ON THE BEP'S MOTHERBOARD.
ON SOME BEPS, THE KEYING TO PREVENT ERROR MAY BE MISSING.
To Next Page
Loading...
