GE
D
IRECTION GB091046, REVISION 2 VIVID E9 / VIVID E7 BT’13 SERVICE MANUAL
Chapter 8 - Replacement procedures 8 - 265
8-11-10 Video Jumper (Flex) replacement
The Video Jumper (Flex) is used in VIVID E9 / VIVID E7 with 2D and without DVR.
The jumper is included in the BEP6.X Cable Kit - Spare Part, Part Number 5433408-80.
8-11-10-1 Preparations
When preparing for the replacement, you must perform the following steps:
1.) Power down the VIVID E9 / VIVID E7.
2.) Disconnect the Mains Power Cable from the wall outlet.
3.) Disconnect all probes and external I/O cabling.
4.) Remove the Left Side Cover.
5.) Remove the BEP Cover.
a.) Loosen the BEP Cover’s fixing screw(s).
- On BEP6 there are two finger screws on the top of the BEP Cover.
b.) Tilt the top of the BEP Cover away from the BEP.
c.) Set the BEP Cover aside.
Related information:
• 4-2-2 "Power shut down" on page 4-8.
• 8-5-2 "Side Covers replacement" on page 8-24.
8-11-10-2 Video Jumper (Flex) removal
Follow these steps to remove the Video Jumper (Flex):
1.) Flip the retainer levers on the side of the connectors CN DV11 and CN DV12 to the side.
2.) Unplug and remove the Video Jumper (Flex).
8-11-10-3 Video Jumper (Flex) installation
Follow these steps to install the Video Jumper (Flex):
1.) Connect the two connectors on the Video Jumper (Flex) to CN DV11 and CN DV12 (on the BEP’s
motherboard).
2.) Install the BEP Cover.
3.) Install the Left Side Cover.
To Next Page
Loading...
