GE
D
IRECTION GB091046, REVISION 2 VIVID E9 / VIVID E7 BT’13 SERVICE MANUAL
8 - 278 Section 8-13 - I/O Modules replacement
8-13-1-3 Patient I/O installation procedure (cont’d)
5.) Install the BEP Cover as described in these steps:
a.) Insert the base of the BEP Cover inside the base of the BEP.
Be sure the bottom lip of the BEP Cover rests inside the BEP.
b.) Tilt the top of the BEP Cover toward the VIVID E9 / VIVID E7.
c.) Install the fixing screw(s) for the BEP Cover:
- On BEP6 there are two finger screws on the top of the BEP Cover.
6.) Install the Left Side Cover, see 8-5-2-3 "Side Covers installation" on page 8-26.
Be careful not to pinch any of the cables when installing the BEP Cover.
To Next Page
Loading...
