GE Vivid E7 - Page 604

GE
D
IRECTION GB091046, REVISION 2 VIVID E9 / VIVID E7 BT’13 SERVICE MANUAL
8 - 288 Section 8-14 - Peripherals replacement
8-14-2-4 BEP6 - Digital Video Recorder installation procedure (cont’d)
6.) Install the BEP Cover as described in these steps:
a.) Insert the base of the BEP Cover inside the base of the BEP.
Be sure the bottom lip of the BEP Cover rests inside the BEP.
b.) Tilt the top of the BEP Cover toward the VIVID E9 / VIVID E7.
c.) Install the fixing screw(s) for the BEP Cover:
- On BEP6 there are two finger screws on the top of the BEP Cover.
7.) Install the Left Side Cover.
8.) Install the BEP Cover as described in these steps:
a.) Insert the base of the BEP Cover inside the base of the BEP.
Be sure the bottom lip of the BEP Cover rests inside the BEP.
b.) Tilt the top of the BEP Cover toward the VIVID E9 / VIVID E7.
c.) Install the fixing screw(s) for the BEP Cover:
- On BEP6 there are two finger screws on the top of the BEP Cover.
3.) Take out the DVD+RW from the DVD drive.
4.) Do a playback from the internal disk by pushing the Playback button.
NOTICE
Be careful not to pinch any of the cables when installing the BEP Cover.
NOTICE
Be careful not to pinch any of the cables when installing the BEP Cover.