System Setup
3-68 Vivid T9/Vivid T8 – Basic Service Manual
5795591-100 English Rev. 3
3-9-7-2 Wireless-LAN Network
NOTE: To configure the Wireless-LAN network, the operator must login
as administrator.
1. Connect the wireless adapter in the USB port.
NOTE: Do not use any type of wireless network adapter other than
a GE-approved adapter.
2. Enter Config (F2)-> Connectivity-> TCP/IP, select
Wireless Settings.
Figure 3-56. Network Settings
3. Either double-click or select network you want to, and press
Connect button.
If this is the first time you attempt to connect to the network,
a dialog will pop up on screen asking you to configure the
network setting.
Figure 3-57. First Time Connection Dialog
To Next Page
Loading...
