Diagnostics/Troubleshooting
7-10 Vivid T9/Vivid T8 – Basic Service Manual
5795591-100 English Rev. 3
7-3-1-3 Reset the P2 Key to Customer’s Functionality
If the customer had programmed the P2 Key to a function other
than screen capture, restore that functionality recorded in
section 7-3-1-1 ‘Setting the P2 Key to Screen Capture’ on
page 7-7. Refer to Figure 7-2 on page 7-6.
1. Seclect Config (F2) on the control panel.
2. Select Connectivity -> Additional Outputs.
3. In the Button field, select Print2.
4. In the Destinations list, select the service(s) recorded in step
5, See 7-3-1-1 ‘Setting the P2 Key to Screen Capture’ on
page 7-7.
5. In the Physical Print Buttons section, select the parameters
related to the service recorded in step 6, see
7-3-1-1 ‘Setting the P2 Key to Screen Capture’ on page 7-7.
To Next Page
Loading...
