EasyManua.ls Logo

GE Voluson P8 - 5-3-3-1 DRFG - FPGA

GE Voluson P8
620 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
GE DRAFT VOLUSON™ P8/VOLUSON™P6
DIRECTION 5775469, R
EVISION 3 DRAFT (JULY 19, 2018) BASIC SERVICE MANUAL
Chapter 5 - Components and Functions (Theory) 5-29
5-3-3-1 DRFG - FPGA
A.) Beamformer interface
• LVDS-interface
• Raw ultrasound data is transferred from the Beamformer to the Interface FPGA.
• Configuration data (Probe Setup data, Beam Setup data) is transferred from the Interface FPGA to
the Beamformer.
• FPGA configuration data is transferred from the Interface FPGA to the Beamformer
B.) DMA Logic
• Receives pre-processed ultrasound data coming from the Processing FPGA.
• Stores this data in the Line Memory buffer (2x SDRAM)
• Transfers buffered data by DMA-transfer via PCI and PCI-Express to the PC
- Non-TimeMotion data (B, C): DMA0
- TimeMotion data (M, PW): DMA1.
C.) T-DPI FPGA programming interface
• This FPGA is the interface between the System connectors and the DRFG.
D.) Ultrasound Data Pre-processing
• Raw ultrasound data is coming in from the Interface FPGA. It is pre-processed.Further processing
will be done by the PC. The pre-processed data is transferred back to the Interface-FPGA.
E.) System control
• PRF (Pulse Repetition Frequency) Generator
• Line Number (Lateral Position)
• Control of TX-Power DACs (generation of TX POWER reference voltage)
• Controls discharge of capacity on DPS board during the reduction of TX POWER
• Shut-down signal coming from the DBM64G board is passed to the SOM
• Probe Select signals, which indicate that a probe is connected to a probe connector.
• Probe Code Interface: The Probe Code can be read from a connected probe, or a new code can be
written into the probe..
• Audio Control:
- PW Doppler Audio Output for buffered signals from the PC
F.) 4D motor control
• Master of Control for 3D-Sweep
• Master of Control for 4D-Sweeps
• Generation of Volume Trigger and Frame Trigger (for 4D)
• Drives motor (in 3D/4D-probes) via SIN (sine-signal) & COS (cosine signal)
• The HALL-signal coming from the 3D/4D probe is passed to the DSP for zero position detection.

Table of Contents