GE XMTC User Manual

Appendix C. Installation and Wiring Diagrams
XMTC User’s Manual 80
GROUPS
NO. DESCRIPTION
01 STANDARD
02 02
03 TC
INSTALL ON PINS 2 AND 3
78
P8
SEE NOTE 2
78
P7
INSTALL ON PINS 2 AND 3
78
P4
INSTALL ON PIN1 ONLY
68
TB1A
70
TB1B
71
TB2B
69
TB2A
SEE NOTE 5
1
ASSEMBLY TOP
NOTES:
1. ASSEMBLE PER IPC-A-610 AND/OR PANAMETRICS STANDARD 957-002.
2. R19 NOT INSTALLED (SPECIALS ONLY).
3. ALL UNINSTALLED COMPONENT HOLES TO BE SOLDER FREE.
4. DISCARD LOCKWASHER AND NUT ON S2 (DO NOT INSTALL).
5. INSTALL P6 WITH LONGER LEADS INTO PCB AS SHOWN FOR PROPER STACKUP WITH MATED ASSEMBLY.
SOLDER MUST BE FLUSH TO BOARD. DO NOT CUT, TRIM OR TIN EXCESS LEADS.
6. INSTALL CHASSIS GROUND WIRE ON THE BOTTOM SIDE OF THE PCB. APPLY LOCTITE 416 INSTANT
ADHESIVE AND LOCTITE 7452 ACCELERATOR OR EQUIVALENT TO TACK WIRE TO PCB.
Figure 69: Digital PCB Assembly (ref. 703-1316, Rev. K, SH1)

GE XMTC Specifications

General

Brand	GE
Model	XMTC
Category	Transmitter
Language	English