GE ZITON ZP3 - Point Screen Display Details

ZP3 Fire Control Panel User Guide
Point screen
The following paragraphs describe how to how to read the LCD Display when it is switched to the
Point Screen. This screen (see Figure 12), is manually accessed by pressing the View Points
button in order to see the device that caused the alarm.
Figure 12: Typical point screen
HELP
ACCEPT
MUTE
BUZZER
RESET FIRE FAULT DISABLED OTHER
SILENCE
ALARMS
SOUND
ALARMS
MORE
VIEW
POINTS
3698
-
0
1
Point Address
FIRE (Point) 1001 callpoint
Exit door in passage stairway
Z001 P01 Zone Message 06:37
======FIRE (01)======================
Type of Alarm
Point Message
Zone Number
Alarm Category
Being Viewed
Type of Device
Time of Alarm
Total Number of
Points in Alarm
Top Row
Second Row
Third Row
Bottom Row
Top row: alarm and device information
• The type of alarm that exists, for example "FIRE", “FAULT", "DISABLED", or "OTHER” is displayed
at the beginning of the row.
• The word Point indicates that you are viewing the point screen.
• The address of the device (or point) is given, for example “1001”.
• The type of device is provided at the end of the row, for example “callpoint”.
Second row: device location
The second row displays the exact location of the device (point), for example “Exit door in
passage stairway”.
Third row: zone details
• The zone number for this device is displayed at the beginning of the row, for example “Z001”
+ zone message for location.
• The time of the alarm (optional) is displayed at the end of the row.
Bottom row: confirms type of alarm shown
• The type of alarm, for example “FIRE”, is shown in line with the associated alarm view button
and “common” alarm indicator.
• The figure in brackets, for example “01” indicates the total number of points in alarm.
Page 16 Revision 11 (05/01/2010)