ZP3 Fire Control Panel User Guide
The ZP3 panel, when fitted with the software specified in the specification supports the following
sensors and devices:
• A45E-2 Single interface module
• A51E-1 High voltage relay module
• A60E-2 Line isolator module
• A50E-2 Line relay module
• A70E-2 Conventional interface module
• ZP710 Ionization smoke sensor
• ZP732 Combination smoke/thermal sensor
• ZP730 Optical smoke sensor
• ZP720-2 Thermal sensor (Grade 2)
• ZP720-3 Thermal sensor (Class A1)
• ZP785-2 Manual "breakglass" callpoint (indoor)
• ZP785-3 Manual "breakglass" callpoint (indoor – 3 second response)
• ZP787 Manual "breakglass" callpoint (outdoor)
• ZP740 Interface unit, multifunction (fire/non-fire/security)
• ZP745 Interface unit
• ZP750 Loop relay
• ZP755 Loop sounder
• ZP755W Weatherproof horn sounder
• ZP755H Horn sounder
• ZP755V-2 Addressable standalone beacon
• ZP755BV-3 Addressable sensor base sounder/beacon
• ZP756 Loop sounder with base
• ZP753 Loop remote LED
• ZP470 Loop radio communication module
• ZR430-1 Wireless (radio) optical smoke sensor **
• ZR420-1 Wireless (radio) thermal smoke sensor **
• ZR432-2 Wireless (radio) combination sensor **
• ZR485 Wireless (radio) callpoint
• ZR440 Wireless (radio) interface I/O unit
• ZP710ex Intrinsically-safe smoke sensor
• ZP720ex Intrinsically-safe thermal sensor
• ZP786ex Intrinsically-safe callpoint
• ZP740ex Intrinsically-safe interface unit
• ZP35-ECU Extinguishing control units
• ZS200 High sensitivity aspirating smoke detectors
• ZX832 Multisensor fire detector (optional)
** Used with the ZP471A and ZP472A Radio interface units only (see Accessories and
peripherals on page 4.
Later software may support additional or different devices. If in doubt, check with your local
supplier.
Revision 11 (05/01/2010) Page 3
To Next Page
Loading...
