Geemarc CL555 - Making a Call

31
Making a Call
Pick up the handset.
When you hear the dialling tone, dial the number on the
keypad.
To end the call simply replace the handset in the cradle
Making a Call – Hands Free
Press the button to get a dialling tone then dial the telephone
number on the keypad. The icon appears on the LCD. To
end the call, simply press again. The icon will disappear.
To activate the Hands Free function during the call, press the
button and replace the handset on the cradle at the same time.
To deactivate the Hands Free function during a call, lift the
handset.
Note: When in hands free mode, only one person may talk at a
time. The switch-over between speaker and microphone is
automatic. This is dependent on the sound level of the incoming
call and the microphone respectively. It is therefore essential
that there are no loud noises, e.g. music, in the immediate vicinity
of the telephone, as this will disrupt the hands free function.
Speakerphone Volume Setting
In hands free mode you can adjust the speaker volume by using
the volume controls VOL+or VOL- located on the right side of the
phone.
30
USING THE TELEPHONE