page | 20
Changing Input and Output Names
By default, the names of the output is Output. The default names for each input are Input
1 - Input 4. Each of these names can be changed, as desired, to suit the type of device
that is connected to the input or output. This allows easy reference when performing
routing operations.
1. Click the Setup tab within the built-in web interface.
2. Click the Names sub-tab.
3. Click in the eld of the desired output or input to be changed.
4. Once all changes have been made, click the Save button.
5. The new names will be displayed within the Routing tab.
Basic OperationBasic Operation
The Web Interface
Basic OperationBasic Operation
To Next Page
Loading...
Need help?
General
