47
CONTROLS
Auxiliary Hydraulic Switches
Auxiliary Hydraulic Buttons (A), (B)
Press those buttons to control the flow of the
oil in the auxiliary hydraulic circuit.
(A) .......... Hydraulic oil flows to auxiliary
hydraulic line (a)
(B) .......... Hydraulic oil flows to auxiliary
hydraulic line (b)
The button turns on when it is pressed, and
turns off when it is released.
¡When 1-way flow is selected by turning
on the flow selector switch (C), the
auxiliary hydraulic button only functions
when side (A) is pressed.
Refer to page 69 “Operating the Auxiliary
Hydraulics”.
Slider Switch (If equipped)
(Proportional control)
Proportional control allows for slow-to-fast
movement of auxiliary functions.
Example: If you move the slider switch half
way, the auxiliary function will move at
approximately one-half speed.
Move this switch to control the flow of the oil
in the first auxiliary hydraulic lines.
Flow Selector Switch (C)
The flow of the auxiliary hydraulic system
(lines (a) and (b)) can be set to either 1-way
or 2-way flow. When the switch is pressed,
the flow switches from 2-way to 1-way and
the built-in lamp (green) lights. When pressed
again, the flow switches from 1-way back to
2-way and the lamp turns off.
O / OFF .. 2-way flow
I / ON .... 1-way flow
The oil in line (b) returns to the
hydraulic tank.
T9B011
If Equipped
T9B012
T9B013
If Equipped
Switches
To Next Page
Loading...
