3
MACHINE DESCRIPTION
■ Front, rear, Ieft and right
This manual refers the front, rear, left and
right of the machine as seen when sitting in
the operator’s seat with the bucket visible to
the front.
■ Designated operations
Use this machine primarily for the following
operations:
¡Carrying
¡Leveling
¡Loading
RIGHTLEFT
REAR
FRONT
T7A004E
■ Features
¡Hydrostatic drive system.
¡Roll Over / Falling Object Protective Structure (ROPS/FOPS) tilt-up ROPS.
¡Rubber crawlers combine the capabilities of a crawler loader.
¡Low engine noise and exhaust emissions.
¡Two-way auxiliary hydraulics.
¡Pilot operated joystick controls.
¡Engine emergency stop system.
■ Break-in period
When the machine is new, heed the instructions below when operating the machine for the
first 100 hours (as indicated on the hour meter).
Using a new machine roughly without breaking it in will lead to quicker deterioration of machine
performance and may shorten the machine’s service life.
¡Warm up the engine and hydraulic oil sufficiently.
¡Avoid heavy loads and rapid operations. Operate with a load of about 80% the maximum
load.
¡Do not start up, accelerate, change directions, or stop abruptly unless necessary.
To Next Page
Loading...
Need help?
General
