58 50950106/AP0313
Lifting the Loader
The loader can be lifted using a single-point or four-point lift kit, which are avail-
able from your Gehl dealer.
• Before lifting, check the lift kit for proper installation.
• Never allow riders in the operator’s compartment while the
loader is lifted.
• Keep everyone a safe distance away from the loader while it is
lifted.
• Loader may only be lifted with an empty bucket or empty pallet
forks, or with no attachment. Never lift the loader with attach-
ments other than those stated.
Lift equipment used and its installation is the responsibility of the party con-
ducting the lift. All rigging MUST comply with applicable regulations and
guidelines.
1. Using suitable lift equipment, hook into the lift eyes. Adjust the length of the
slings or chains to lift the loader level.
Note: The loader my be slightly off level (10 degrees max.) when lifted.
2. Center the hoist over the ROPS/FOPS. To prevent shock loading of the equip-
ment and excessive swinging, slowly lift the loader off the ground. Perform
all movements slowly and gradually. As needed, use a tag line to help posi-
tion the loader and keep it from swinging.
To Next Page
Loading...
Need help?
General
