EasyManuals Logo

Gehl R220 User Manual

Gehl R220
130 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #64 background imageLoading...
Page #64 background image
60 50950106/AP0313
Regeneration Terms and Definitions
DPF: Diesel Particulate Filter
Regen: Typically refers to the reset or stationary regeneration mode of the DPF,
but could also refer to other regeneration modes, such as an assist or passive
regeneration.
PM: Particulate matter in the DPF
Hours: Refers to the engine run-time hours
E-ECU: Refers to the Engine-ECU Control Unit
DTC: Diagnostic Trouble Codes
EGT: Exhaust Gas Temperature
Passive regeneration and assist regeneration: These automatic DPF regen
modes occur without any operator input and without affecting machine opera-
tion.
Reset regeneration: This DPF regen mode intentionally increases exhaust gas
temps to remove PM. Review all precautions regarding high exhaust temps. The
operator can continue to operate all skid-steer loader functions. Reset regenera-
tion is initiated by the E-ECU, but the operator has the option to delay this func-
tion. A reset-regeneration is a 100 hour recurring event unless other factors, such
as engine load and effective PM levels determine otherwise.
Note: The operator can improve the effectiveness of the reset regen by oper-
ating the skid-steer loader at a middle to high throttle position during the reset
regen.
Stationary Regeneration: This DPF regen mode includes engine speed control
for a more effective and complete DPF regen. When the DPF regen-required
lamp illuminates, the operator should move the skid-steer loader to a safe place
without flammable material nearby before operating the stationary regen. For
operation and other details, refer to the flow chart and stationary regen operating
procedures.
Backup Mode: In the backup mode, the engine has reduced revolutions per
minute (RPM) and power. A number of DTC’s are to be expected. Refer to the
DTC listing (page 81) for a complete summary and troubleshooting techniques.
To cancel the backup mode, the service tool (Smart Assist) is required. Contact
your dealer for full details.
Ash Cleaning Mode: The ash cleaning mode details are under development.
Contact your dealer for information.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Gehl R220 and is the answer not in the manual?

Gehl R220 Specifications

General IconGeneral
Engine Power70.7 hp
Rated Operating Capacity2, 200 lbs
Tipping Load4, 400 lbs
Engine MakeYanmar
Hydraulic Pressure3, 335 psi

Related product manuals