Gehl R220 - Page 78

74 50950106/AP0313
Lubrication Procedure
10 Hours
(or Daily)
50
Hours
250
Hours
500 Hours
(or Yearly)
Check Engine Oil Level (page 80)

Check Hydraulic Oil Level (page 87)

Grease Hitch, Hitch-related Cylinder Pivots
and Latch Pins (page 73)

Grease Lift Arm Pins (page 73)

Check Oil Level in Chaincases (page 75)

Change Engine Oil and Filter (page 80)

Change Hydraulic Oil Filter (page 87)

Change Hydraulic Oil (page 88)

Change Chaincase Oil (page 75)

Check and Drain Water Separator (page 81)

Replace Filter in Water Separator (page 81)

50/250
250
10
50/500
500
250
Figure 36 Service Locations (see Maintenance Chart on page 103.)
 Perform the initial procedure at 50 hours, then at the indicated intervals.