Template Date: 1997_02_12
STEP 15
G0905069
Loosen the two axle mounting bolts located in back
of the axle. Do not remove the nuts at this time.
STEP 16
G905071
Place two 10-ton hydraulic bottle jacks under the
frame in the location shown and apply upward
pressure equally from side to side on each jack.
Raise until the front wheels are approximately 2
inches off the surface.
STEP 17
Adjust the jack stands to a height that will keep the
wheels approximately 2 inches off the surface when
the bottle jacks are removed.
STEP 18
Lower the bottle jacks equally and remove.
STEP 19
G0905072
Using a 5-ton floor jack, placed under the center of
the differential housing, apply upward pressure on
the axle.
NOTE:
The front axle cannot be rolled out from
under the machine on the wheels because the park
brake is spring-applied.
STEP 20
G0905056
Loosen and remove the wheel nuts from the wheel
bolts.
STEP 21
Remove both wheels and tires from the axle.
STEP 22
Remove the two axle mounting nuts and bolts
located in back of the axle.
To Next Page
Loading...
