25. Procedures for Maintenance
3-38
8) After washing with running water, stop the engine, stop
pouring water, drain water completely and then securely
reinstall the drain plug and the bottom cover.
9) Pour water mixed with anti-freeze through the water
supply port of the radiator to fill it up.
10) To release air, idle the engine for 5 to 6 minutes and
then run the engine without load at high speed for 5 to
6 minutes. (While running the engine, keep the radia-
tor cap removed.)
11) Approximately 5 minutes after stopping the engine,
pour water mixed with anti-freeze up to the water sup-
ply port of the radiator, and install and tighten the cap.
12) Open the engine hood rear cover, drain the cooling
water from the sub-tank (1), wash the inside of the
sub-tank (1) and pour water mixed with anti-freeze up
to the "FULL" level.
(1)
FULL
LOW
015412-00E
To Next Page
Loading...
