12. Description of Control Devices
2-22
The fuse protects the electrical equipment and wiring from
becoming overheated. If the fuse is corroded with white
deposits or if the fuse is loose in the holder, the fuse must
be replaced with a new one.
Position of the fuse box
Blade fuse
It is installed on the front left of the seat mount.
Slow-blow fuse
It is installed by the battery inside the engine hood rear cover.
Replacing the fuses
If the electrical equipment does not operate, the fuse may
have been blown out. Follow the procedure below:
1) Set the starter switch at the “OFF” position.
2) Remove the fuse box cover.
3) If the fuse is blown out, replace it with a spare fuse of
rated capacity.
12-15. Fuse
• When replacing the fuse, be sure to turn off the pow-
er by setting the starter switch at the OFF position.
• Using a wire, aluminum foil or the like instead of the
fuse could cause burnouts of the gauges, the elec-
trical equipment and the wiring due to overheating.
• If a new fuse is blown out immediately after replace-
ment, there may be a problem with the electrical sys-
tem. Ask the nearest dealer for check and service.
000370-00X
009023-00E
Storage box cover
Fuse box
Open
30A15A15A 5A
15A
15A 5A 15A
15A
30A
Fuse box
A
B
D
F
H
I
C
E
J
G
000371-00E
Battery
Engine hood
rear cover
Slow-blow
fuse
015409-00E
Symbol
Fuse
capacity
Circuit name
A
B
C
D
E
F
G
H
I
J
15 A
30 A
15 A
15 A
15 A
15 A
30 A
5 A
5 A
15 A
Room lamp , Window washer ,
Quick coupler , Heater , Air conditioner
Air conditioner
Horn, Head lamp , Monitor light,
Boom lamp, 2-speed travel valve,
Cab or Canopy lamp
Wiper , Heater relay
Timer, Safety relay, Generator,
Fuel feed pump, Engine stop solenoid
Indicator box, Buzzer,
Cut-off valve, Travel alarm
Radio , Controler
Spare
The oblique character parts:
Applicable to models with the relevant equipment.
To Next Page
Loading...
