25. Procedures for Maintenance
3-55
How to release air:
1) Fill up the fuel tank.
2) Set the accelerator lever to the "RUN" position.
3) Turn the starter switch to the "START" position to crank
the engine for approximately 10 seconds.
Air is automatically released and the engine starts.
IMPORTANT
If the engine is not started after this procedure, turn
the starter switch to the "OFF" position after 10 sec-
onds and at least a minute later turn it to the "START"
position again to restart the engine.
When you refuel, release air in the same way; that is, crank
the engine for 10 seconds four or five times.
After the engine starts, sometimes it revolves irregularly
and stops approximately 20 to 30 seconds later. In this
case, turn the starter switch to the "OFF" position, wait for
one minute or more and turn the starter switch to the
"START" position again.
To Next Page
Loading...
