12. Description of Control Devices
2-8
(2) Light switch
The boom light and the headlight go on when the switch is
turned on with the starter switch set to the “ON” position.
• ON : The lamps go on.
• OFF : The lamps go off.
IMPORTANT
Do not keep on the lamps on for a long time while the
engine is not running. The battery runs down and the
engine cannot be started.
(3) Horn switch
Press the switch on the top of the right control lever to
sound the horn.
(4) Wiper and windshield washer switch (for cabin)
This switch serves both wiper switch and windshield wash-
er switch.
1) Wiper switch
Move the switch to the "ON" position to actuate the wiper
of the windshield.
• ON : Wiper works.
• OFF : Wiper stops.
2) Windshield washer
Push the wiper switch.
The windshield will be sprayed with windshield washer fluid.
IMPORTANT
• Do not push the switch when the tank is empty.
It could cause pump failure.
• Wiping the dry windshield could damage the glass.
Use the wiper only when the windshield is wet.
• The wiper blade may freeze in cold weather. Do not
attempt to move it; otherwise the wiper motor will be
damaged.
ON
OFF
000328-00X
009001-00E
Press
015403-00X
To Next Page
Loading...
