13. Operating Instructions
2-33
13-1-3. Operating and checking instructions before
starting up the engine
1) Check that the lock levers (1) are in the lock position.
Note :
When both the lock levers are in the unlock position, the
engine cannot be started. Pull either lock lever up to start
the engine.
2) Check that all other levers are in their appropriate posi-
tions.
3) Fasten the seatbelt snugly.
4) Insert the key into the starter switch (2) and set it to the
"ON" position. Then check the following points:
[1] The buzzer will sound, and the following alarm lamps
will go on.
• Engine oil pressure alarm lamp (3)
• Battery charge alarm lamp (4)
• Water temp. alarm lamp (5) (turns off in 2 to 3 seconds)
If any of the alarm lamps does not go on or the buzzer does
not sound, it may mean that the alarm lamp has blown out
or the wire is broken. In this event, ask the dealer for repair.
[2] Position the light switch to "ON" whether the head light
and boom light will go on. If they do not go on, the lamp
might have blown out or the wire might be broken. In
this event, ask the dealer for repair.
• Accidentally operating a control lever can cause
the machine to move suddenly, possibly causing
a serious accident.
• When leaving the operator's seat, be sure to
place the lock levers securely in the lock posi-
tion.
ON
OFF
000328-00X
015561-00X
(1)
(1)
(2)
Lock
(Left side)
(1)
009042-00E
009043-00E
Seatbelt
009225-00X
(3)(4) (5)
022512-00X
To Next Page
Loading...
