Pag.5
so that the necessary verification can be performed, or the material must be shipped to
GEM when the company so requests in writing;
1.4.8.4 – absolutely no claims will be accepted for warranty repairs that were not previously
authorized in writing by GEM;
1.4.8.5 – in any case, a complete photographic report of the executed repair operation must be
supplied to GEM. The purpose of this study is not only to record the repair procedure
but also to enable GEM to correct the problem and improve the quality and reliability of
the machines;
1.4.8.6 – GEM reserves the right to ask back defective materials in order to check the cause of
the problem. If defective materials don’t reach GEM factory within 30 days from request
the new parts will be invoiced to the customer.
2
Safety instructions
2.1
General
The GEM GLSxx elevator machine is not a ready-to-use product and may only be operated
after
having been installed in machines or plants and its safety, depending on the application, has
been
ensured by protective grids, barriers, constructive devices or other adequate measures (see
EN ISO
13857)!
Installation, connection to the power supply and commissioning may only be performed by qualified
service personnel! The relevant regulations (both European and National) must be observed!
Installers, manufacturers and operators of system parts or entire systems are responsible for the
correct and safe mounting and a reliable operation.
2.2
Intended use
The GLSxx is a permanent-magnet, gearless elevator machine, designed as an internal rotor
motor
for elevator with and without a machine room. The elevator machine is not designed for any use
other
than those listed here – this is considered improper use.
Applications other than the intended use of this elevator machine are not permitted without
approval by GEM General Elevator Machines S.r.l..
Reading these operating instructions and complying with all instructions - especially the safety
instructions - is considered part of intended use. It also includes carrying out all the
inspection work at
the prescribed intervals.
Not the manufacturer, rather the operator of the GEM GLSxx is liable for any personal harm or
material
damage arising from non-intended use!