○○○○○○○○○○○○○○○○○○○○○○
Disk & Hard Disk 3•31
3. Press ENTER to confirm or ESCAPE to cancel.
As a security measure, a second confirmation re-
quest appears (for security reasons):
4. Press the Soft button F1 (not ENTER) to start the
hard-disk format procedure, or ESCAPE to can-
cel.
HARD DISK CHECK/RECOVERY
This procedure can restore a damaged Hard Disk
to its original status.
Damage to the Hard Disk
can be caused by:
• a power failure during a Save operation;
• physical defects of the disk.
If the Hard disk is damaged, attempting to ac-
cess it prompts a message similar to the follow-
ing:
Use the following recovery procedure as soon
as possible.
1. Enter «Edit Disk» and go to the «Hard Disk Util-
ity» page.
2. Select «Hard disk check/recovery» .
The following dialog window appears:
3. Press ENTER to start the recovery of the data.
Shortly after, another dialog window appears
similar to the one below:
In this case, the message shows no errors.
In cases where errors exist, make a note of
the numbers shown in the dialog window as
they are useful to provide information for tech-
nical assistance.
• Check version - Version of the test pro-
gram and data recovery.
• Error found - Code relating to the error
found. “None” appears in cases where no
errors are encountered.
○○○○○○○○○○○○○○○○○○○○
©
WARNING - Never turn off the instrument while
the Hard disk or disk drive are writing data (Save,
○○○○○○○○○○○○○○○○○○○○
Copy, Move, Erase operations).
HARD DISK SLEEP TIME
To avoid hearing the noise caused by the rota-
tion of the hard disk, you can set this parameter
to turn the hard disk off after an operation.
Options: Off (always on), 5 sec ... 60 sec.
To Next Page
Loading...
Need help?
General
